KRK ROKIT 5 G2 Betriebsanweisung PDF herunterladen (Seite 9)

Audio Input

10kohms Balanced

Pin 2 & Tip = Hot\Positive

Pin 3 & Ring = Cold\Negative

Pin 1 & Sleeve = Ground

Connecting You r System

IMPORTANT: All connections should be made, all fader

and controls should be set at their minimum levels, and

all other equipment should be powered prior to powering

up your RoKit G2 monitors.

NOTE: Ensure that the voltage indicator found in the voltage

selector is set to the correct voltage setting for your local supply.

Powering On

The power On/Off switch is located on the rear panel. The KRK

logo on the front face plate illuminates when power is applied.

Changing Voltage

To change the voltage, remove the power cord and slide the

voltage selector to the desired voltage setting. Please note that

when making voltage changes, the fuses will have to be replaced

(refer to the Changing Fuses section on page 17).

Changing Fuses

Under normal operation the fuses should not blow. A blown fuse

usually indicates an overload or fault condition. To change the

fuse, remove the power cord, pry off the fuse block with a small

flathead screwdriver and change the blown fuses. Refer to the

Specifications section on page 17 for fuse current ratings.

NOTE: If the fuses blow immediately upon power up, this

indicates a fault condition and KRK Customer Service should be

contacted at 1-800-444-2766 or [email protected].

Audio Inputs

The XLR and TRS inputs are balanced while the RCA input is

unbalanced.

Unbalanced

Balanced

rokit_manual REV E_rokit_manual 2/19/13 10:24 AM Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Keine Kommentare

KRK ROKIT 5 G2 Betriebsanweisung Seite 9